turnigy trackstar esc

[elsewhere]

got one of these here, its for a 1:18 vehicle.
its got a 26mm by 30 mm foot print IN the case, its a lot smaller without it.
the esc is a brushless model, all my other brushless escs can run brushed motors, anybody know if this esc will support a brushed motor?

i have a 4500kv brushless motor here but im afraid it might cog like mad.
was looking at doing a big block 130 can 80t motor, and want to use this esc...

 

[spoo76]

Brushless only. you could try the hexitronic 5gram outrunner. there are a few links and info when you search the micro forum for "outrunner"

 

[Evilinside]

Yes your motor will cog like mad. I put that setup in a Losi Micro buggy.

 

[elsewhere]

And again,
BOB SAGET!
Outrunner it is.

 

[elsewhere]

5g outrunner on the way from china.