Vanquish currie rear axle shaft broke

[Crawl for beer]

Hi,

Need some help. I got got a yeti with the centered vanquish currie. I was running it in the front yard and the wheel came off along with the threads to the axle shaft.

Now I've got it apart but the shafts won't slide out of the pumpkin. I have the axles off so it's not the 3 set screws per side. It just won't pull out of the diff.

Any tricks?

Thanks

 

[m0nster]

there's a c clip in the end of the axle tube holding the bearing in.

 

[Crawl for beer]

Thanks. I got the axle tubes off yet the shafts are still attached to the center diff.

It's driving me nuts!

Left this out in the OP. The diff is locked and not open. Might make a difference

 

[Crawl for beer]

Got it.

Pulled the diff cover and cleaned out the grease.

Once I did that I saw the large grub screw that holds the shaft in place.