Where to find a emaxx tranny mount for the txt-1 or juggernaut?

[nitrofume]

I want to put a emaxx tranny in my jugg 2 and dont know where or if i can still get the emaxx tranny mount.Anybody have any ideals it would be appreciated.

 

[Mazlem]

Do you want the two speeds or just to have a different tranny? InetRC used to sell conversion kits but I don't see any on their site now. Thundertech Racing used to have full kits including the transmission, but they were ~$150.

 

[nitrofume]

Do you want the two speeds or just to have a different tranny? InetRC used to sell conversion kits but I don't see any on their site now. Thundertech Racing used to have full kits including the transmission, but they were ~$150.

I just wanted to put a brushless e-maxx single speed tranny cause ill be running a vxl and just want the tranny gears to hold up.I know the brushless emaxx will defiantly take it.Just need to mount it.I know some company made just the mounts but that was along time ago.I'm kinda in the jugg game way to late for all the nice parts.

 

[Mazlem]

The Jugg2 trans is pretty stout; should be easier yet to give that a try.

 

[muddawg]

the txt1 has the same tranny i was a little worried because it came with an extra set of tranny gears and i have enough power to wheely on demand. ibreak drive shafts and have broken every part in the axles but the tranny has held up fine"thumbsup"

 

[Brainstain]

I was just looking for the same thing and couldn't find it. I know RC4WD had one but I can't find it on their site.

 

[william g]

all it was was some cutup alum angle and a few holes

as for driveshafts, REVO shafts are the way to go the stock drive shafts break too easy. Just cut to proper length