Wooster[44691] - Under Construction - Post#1=Address/Directions/Pics

[scrounge]

Thanks Dane, had a blast yesterday. Can't wait to get back up there and crawl again. For your FIRST comp, you did some mighty fine driving.

I WILL get some pics posted soon.....

 

[OhioCrawler]

Thanks Dane, had a blast yesterday. Can't wait to get back up there and crawl again. For your FIRST comp, you did some mighty fine driving.

I WILL get some pics posted soon.....

Any luck on the pics?

 

[scrounge]

have it figured out.......thank you eric. will have pics posted later tonight.

 

[holycaveman]

Anyone up for a Sunday comp?

 

[EDGE]

I'm out gotta work

 

[OhioCrawler]

Of coarse im in. Just keep me posted if anything comes to be. Its our busy season here at work so ive been slacking on weed pulling maintenance but if needed ill make sure its in my schedule for sure this week!

 

[josh6575]

I would like to but it would have to be home by 4 to attend a graduation party.

 

[Frank Rizzo]

I'm leaving for TN.

 

[josh6575]

May do cleveland instead. I have never crawled there and it looks awesome.

 

[OhioCrawler]

May do cleveland instead. I have never crawled there and it looks awesome.

Cool.

Either way im starting to have issues with my rear motor stalling for about 3-4secs after the front turns on. Seems like its making a slight hum during that those few seconds, and once i give enough throttle it starts up. Pain to drive since its unpredictable.

 

[josh6575]

Sounds like mesh is too tight, Burnt commutator, or a bad bearing. Hope you get it figured out.

 

[OhioCrawler]

Sounds like mesh is too tight, Burnt commutator, or a bad bearing. Hope you get it figured out.

I yanked it out of the rig last night, to bench test with no load. Hums with light throttle, then kicks on at or above 1/4 throttle. No excessive noise from the motor. Guess itll get a trip back to Tekin...