Got this chassis

[Crawlernoob73]

So I got this chassis from everyone's favourite auction site



I'm wanting to build a scale rig, I already have a clod body so am wanting to use that somehow.

Can anyone point me in the right direction on where to start, I've downloaded the scx10 manual so figure I'll go through that and see what's needed.

[Brake Weight]

That looks like one that fits the D90. I'm currently working with one but I've lost interest for now keeping all my other RCs running for myself and my kids.

The one I got, but it didn't cost this much when I got it.
https://m.banggood.com/Tian-Chuang-L...ds=orderdetail

The black 2:1 transfer cases on fleaBay are a direct fit if you can come up with a front mounted motor/tranny.

[Crawlernoob73]

Thanks Brake Weight,
I'll get the research going on the front mount servo/tranny as this is what I was looking to do. There's plenty of rigs out there with this done, just hope someone's taken the time to do a "how to"

[Brake Weight]

I believe most all of the RC4WD stuff will be a direct fit. It's more pricey than I wanted to spend so I'm leaning towards building a tranny similar to what GCM did for the SCX10.

Servo mount is easy.

[moohfeernandes]

What panhard system do you plan to use ??

Enviado de meu 81s usando Tapatalk

[Brake Weight]

I haven't sorted that far ahead. Likely just make a short link and a small bracket similar to other CMS 'kits' have.

[Brake Weight]

@Crawlernoob73


Check out DollarHobbyz for a reasonably cheap front mounted RC4WD R3 tranny and motor mount. I'm not 100% sure it's a direct fit, but I can manage a couple of homemade mounts if it isn't.