|
| LinkBack | Thread Tools | Display Modes |
04-20-2012, 03:38 PM | #1 |
Rock Crawler Join Date: Nov 2008 Location: missoula
Posts: 898
| Need some driveshafts long for axial build
My front tranny to diff is 134 mm and rear is 140 mm any one know where i can get these axial tranny 5 mm output and wraith axles 5 mm output
|
Sponsored Links | |
04-20-2012, 04:12 PM | #2 |
Quarry Creeper Join Date: Jun 2011 Location: butler pa
Posts: 477
| Re: Need some driveshafts long for axial build
Rc4wd punisher shafts very strong
|
04-20-2012, 05:58 PM | #3 |
Rock Crawler Join Date: Nov 2008 Location: missoula
Posts: 898
| Re: Need some driveshafts long for axial build
What length should i get if i can find them i dont know how much travel they need at all
|
04-20-2012, 09:15 PM | #4 |
Quarry Creeper Join Date: Apr 2006 Location: SO CAL
Posts: 312
| Re: Need some driveshafts long for axial build
Not sure exactly the style your looking for (plastic, mip splines, etc) but, the MIP Summit shaft works with the Axial splines as well. This allows for a much longer driveline but still the same 'beef' of the MIP setup. These may be to long, but trimming it down shouldn't be to hard. 143mm 119mm MIP Spline CVD Bone, Traxxas Summit (1) MIP C-Drive Female Bone, Axial AX10 (1) |
04-20-2012, 10:28 PM | #5 |
Rock Crawler Join Date: Nov 2008 Location: missoula
Posts: 898
| Re: Need some driveshafts long for axial build
The 143 one can a guy run it that extended?
|
04-20-2012, 10:35 PM | #6 |
Quarry Creeper Join Date: Apr 2006 Location: SO CAL
Posts: 312
| Re: Need some driveshafts long for axial build |
04-21-2012, 12:50 AM | #7 |
Rock Crawler Join Date: Nov 2008 Location: missoula
Posts: 898
| Re: Need some driveshafts long for axial build
Wow ok that would be perfect thankyou
|
05-14-2012, 12:06 AM | #8 |
Rock Crawler Join Date: Nov 2008 Location: missoula
Posts: 898
| Re: Need some driveshafts long for axial build
How much does the axle have to be in the outer to be safe?
|
Need some driveshafts long for axial build - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Axial driveshafts | Axialfreak98 | Axial SCX-10 | 9 | 02-04-2011 12:29 PM |
Custom long driveshafts? | Grind | General Crawlers | 4 | 04-09-2009 12:52 AM |
| |