How tight should the Dig servo screw be?

[Kingmeow]

Not the mounting screws but the single screw that goes into the servo. Do I crank it down until it can't go anymore?

I'm asking to see how tight the servo saver pieces (the wavey ones that mate onto each other) should be. Should there be a gap between the two pieces or no space fully engaged.

Back to my Capra build after a 2 month life-gets-in-the-way delay.

[Airmaxx23]

Originally Posted by Kingmeow

Not the mounting screws but the single screw that goes into the servo. Do I crank it down until it can't go anymore?

I'm asking to see how tight the servo saver pieces (the wavey ones that mate onto each other) should be. Should there be a gap between the two pieces or no space fully engaged.

Back to my Capra build after a 2 month life-gets-in-the-way delay.

Tighten the screw right up, there should not be a gap between the two parts.

[Kingmeow]

Thanks! Got it all figured out tonight.