Axle Options

[monsterman]

Ok guys I know its been talked about or asked I am sure but I've searched through page after page and have had hit and miss reads so here we go..

I want to change out my axles. I've managed to crack the stock axle twice so I was thinking of going with the K44 Ultimate Axles.. From what I can figure out on here and the RC4WD website I just need to order the Front&Rear Axles along with the following below otherwise I am pretty sure thats all I need to mount these up right??

K44 Ultimate Scale Front Axle (Part Number Z-A004
K44 Ultimate Scale Rear Axle (Part # Z-A0049

K44 Ultimate Scale axle 4 link mount (Part # Z-S0133)

ARB Diff Cover (Part #)

Now unless I am totally missing something else option wise I am guessing these will be my next best bet?

[im gunna crawl]

Go to vanquish products they just came out with new housings. Scx10/ax10 width. I dont know much about them though? Mine are due to be delivered tomorrow (thursday) so ill check them out and know more. Should have them mounted by the early weekend! Ive cracked 2 front plastic scx10 housings (they didnt break, i noticed them when i took the axles apart for maint.) Out by the c hub portion.

[monsterman]

Originally Posted by im gunna crawl

Go to vanquish products they just came out with new housings. Scx10/ax10 width. I dont know much about them though? Mine are due to be delivered tomorrow (thursday) so ill check them out and know more. Should have them mounted by the early weekend! Ive cracked 2 front plastic scx10 housings (they didnt break, i noticed them when i took the axles apart for maint.) Out by the c hub portion.

Ah ok thanks for the heads up I didnt know they came out with anything new for the SCX10.. I just got over drooling over some of their new Hpi Baja parts a few months ago!!!

[Meatwad]

Beef tubes will help with the plastic housings. I refuse to run an ax/scx plastic housing without them anymore, the front only at the very least.

[monsterman]

Originally Posted by Meatwad

Beef tubes will help with the plastic housings. I refuse to run an ax/scx plastic housing without them anymore, the front only at the very least.

Sorry guys but my terminology isnt quite as caught up as yours..

Beef tubes?? Or are you just basically saying go Aluminum or Billet with the Front Axles?

[Solitaire]

http://www.rccrawler.com/forum/axles...e-updated.html

[Meatwad]

^ that and this will help visualize:
http://www.rccrawler.com/forum/axial...b-install.html

[monsterman]

Originally Posted by Solitaire

http://www.rccrawler.com/forum/axles...e-updated.html

Originally Posted by Meatwad

^ that and this will help visualize:
http://www.rccrawler.com/forum/axial...b-install.html

Thanks guys now that helps a lot.