| |
10-14-2014, 12:27 PM
| #1 |
| Newbie Join Date: Nov 2010 Location: Milford
Posts: 38
|  Homemade links
Thanks to the good threads on here I built a set of links for the deadbolt today. McMaster shipped the stainless rods and tube very fast. Ended up using the Jato ends. I like the thread depth on those. I didn't have a pipe cutter so I used a hacksaw. Next time I'll get a cutter. The edges were rough.
Last edited by fatcalves; 10-14-2014 at 01:47 PM. |
|  |
| Sponsored Links | |
| | |
|
10-14-2014, 12:50 PM
| #2 |
| Quarry Creeper Join Date: Aug 2014 Location: San Diego
Posts: 260
| Re: Homemade links
That looks nice man. Where do you get the tubing for it?
|
|
| |
|
10-14-2014, 01:49 PM
| #3 |
| Newbie Join Date: Nov 2010 Location: Milford
Posts: 38
| Re: Homemade links
Came from McMaster-Carr. McMaster-Carr Part # 8978K12 tubing Part#98847A009 threaded rod Traxxas Jato ends #5525 Total cost was about $13 total |
|
| |
 |
Homemade links - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Got a question about homemade links | Grabbem88 | General Crawlers | 2 | 11-18-2012 07:28 PM |
| homemade links | crawlerbeast | Axial AX-10 Scorpion | 12 | 07-10-2012 10:11 AM |
| Homemade links? Need help | jhop1 | Axial SCX-10 | 8 | 11-25-2011 08:55 PM |
| Homemade Links | JW615 | Axial AX-10 Scorpion | 4 | 05-02-2008 12:15 AM |
| Homemade links | ede670 | Newbie General | 2 | 07-19-2006 02:18 PM |
| |
Linear Mode
