|
| LinkBack | Thread Tools | Display Modes |
08-14-2016, 07:58 AM | #1 |
Quarry Creeper Join Date: Jun 2007 Location: east michigan
Posts: 269
| Length of mip c drive driveshafts
I've searched can't seem to get the answer I'm looking for. Here's what I got......I have a scx10 honcho. Im wanting to install my rc4wd ax2 2speed trans. I read that mip 09137 fit for the rear, but what about the front? I really would like a working length of these shafts? Thanks in advance! |
Sponsored Links | |
08-14-2016, 07:51 PM | #2 |
I wanna be Dave Join Date: Jul 2009 Location: Rancho Relaxo. California. USA. Earth.
Posts: 3,292
| Re: Length of mip c drive driveshafts They're pretty much all the same, exceptions being the hubs on the wraith set and short male shaft on the ax10 dig set. If its too long and the dig shaft is too short, one can always take .250" or so off of them without issues. |
Length of mip c drive driveshafts - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mip drive shaft #14390 length? | navyeoseabee | Axial Yeti | 2 | 03-29-2015 07:25 PM |
MIP drive shaft length....... | bob1961 | General Scale Talk | 3 | 12-12-2010 04:30 PM |
| |