| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
07-13-2021, 01:49 PM
| #1 |
| Newbie Join Date: Mar 2015 Location: Denver
Posts: 11
|  Switching my 10 III to a brushless setup. What about the lighting?
I'm moving my RTR to a Castle Mamba X setup. For the lights, what wire would I need to buy to plug into my receiver? Are they just servo extension cables? Since it is 2 cables, could I just get a single Y cable that connects to both one one end and plugs into one channel on the receiver? Last edited by synic; 07-13-2021 at 01:55 PM. |
|  |
| Sponsored Links | |
| | |
|
07-13-2021, 02:03 PM
| #2 |
| Newbie Join Date: Mar 2015 Location: Denver
Posts: 11
| Re: Switching my 10 III to a brushless setup. What about the lighting?
I managed to find a splitter in an old drawer and it worked fine. This can be closed.
|
|
| |
|
Switching my 10 III to a brushless setup. What about the lighting? - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Switching to brushless so which one | theficitguy | Electronics | 3 | 02-18-2016 01:27 PM |
| Lighting setup | kardel | Newbie General | 2 | 04-10-2015 06:28 AM |
| switching to brushless gearing question | booher26 | Axial Wraith | 4 | 02-20-2012 08:12 PM |
| Switching to brushless with out replacing my ESC | jonspot25 | Electronics | 4 | 08-29-2011 07:27 AM |
| Any interest in switching 5 lighting circuits remotely? | heyok | Electronics | 30 | 01-26-2011 07:49 AM |
| |
Linear Mode
