Tekin RS Pro ESC Setup - Crawler

[xerocomm]

OK, my two Tekin RS Pro ESC's arrived and I am ready to program them with the Hotwire. I need some recommendations, what do you feel would be a good "starting point" for my crawler?

This is what I have so far:

Drag Brake: 100
Reverse Strength: 100
Brake Strength: 100
Neutral Width: 10
Motor Type: BF-F/R
Throttle Profile: 2
Voltage Cutoff: 3
Push Control: Off
Timing Advanced: Min
Current Limit: Off

Any recommended changes?

I am using 3 Cell LiPo with a Speedpassion KV1100 Crawler Master L Brushless Motor.

Thanks!