| |
08-22-2010, 07:02 PM
| #1 |
| Rock Stacker Join Date: Aug 2010 Location: Stewartstown
Posts: 85
|  loosing throttle
I have a mamba max pro, external BEC (factory setting volts, stock axial servo (RTC kit), and a DX3 with that said my question is. ill be crawling for 10 mins and then all of a sudden ill lose forward and reverse but still have steering ill pick it up and everything works. sit it down again and with 30 secs or min same thing and im not always in a bind or hard spot when it cuts out. should i turn the BEC up i just wasnt sure if the stock servo could handle it i have a 7954sh on the way
|
|  |
| Sponsored Links | |
| | |
|
08-22-2010, 07:07 PM
| #2 |
| Rock Stacker Join Date: Aug 2010 Location: Stewartstown
Posts: 85
|
also the green and red lights are coming on like they are supposed to its just not moving
|
|
| |
|
08-22-2010, 07:19 PM
| #3 |
| I wanna be Dave  Join Date: Dec 2009 Location: San Francisco
Posts: 2,236
|
Im not totally familiar with your esc in particular but I would say recalibrate and see if that helps. Whats your battery voltage when this is happening?
|
|
| |
|
08-22-2010, 07:37 PM
| #4 |
| Rock Stacker Join Date: Aug 2010 Location: Stewartstown
Posts: 85
|
my battery is no where near dead 1300 mAh 3s and i charged to it so see and it was at 12.6 staring out on the charge and my cutoff is 9
|
|
| |
|
08-22-2010, 08:52 PM
| #5 |
| Rock Stacker Join Date: Aug 2010 Location: Stewartstown
Posts: 85
| 
i figured it out the red wire was broke off right at the speed controller board. my brand new mamba im not very happy this is my first castle product and my last cause this isnt the first problem i have had. i soderd it back and everything is good
|
|
| |
 |
| |
Linear Mode
