Dual motor and fxr esc's to Dx6i problems??

[Team KICKASS]

Hey there, a bit confused on what is happened with my setup in my berg 2.2. From a standstill, the truck has clodstall on the rear axle very bad and when i hit full throttle on the controller the front motor/esc hits the limit and flashes but the rear motor/esc doesnt flash and i have to push the second stick to get the rear motor/esc to flash. If anyone can help me, any input would be awesome or even details on how to fully reprogram the whole truck (controller, esc's) with this set up please let me know how i can do so.

Cheers, Kurt

[SMR 510RR]

1. Recalibrate both esc's...I like to do both at one time to eliminate any difference from on to the other (this will require some skill or another person to help you).
2. Check programing on the esc's. I run everything the same except a little less drag brake on the front esc.
3. Check radio programing. Go to your mix programing and make sure that everything looks right. Also go to your monitor screen and verify that both throttle channels are sending equal signals. Also make sure that in the mix the trim is set to inhibit.

That should get you going in the right direction.