Bad digging?

[Krawler23]

I bought a tekin 35 combo x2 for my xr 10 so i can use a dig. The only thing tho is that when i use dig the rear motor still spins a little instead of completely stopping. Is this due to just a poor motor or can i change some settings on my fxr? Here is a link to my combo... Thanks again for the awesome support.
These are 55's but mine are 35's. This is machine wound correct or hand?
https://www.ckrccrawlers.com/images/...XRT55Combo.jpg

[TSK]

What do you have your drag brake settings at?

Looks like a machine wind.

[SMR 510RR]

First thing to do is up your drag brake. If that doesnt help then it would probably be a calibration issue, re calibrate and you should be good to go.

[Krawler23]

i dont have any drag brake so that could be why. I will up it to say 4 maybe? I am not sure what most use so any help there is always good. Thanks for the help

[frdtrkguy]

Mine are maxed out all the way up. FWIW

[SMR 510RR]

I adjust mine with the Hotwire but I usually run 75% on the rear ESC and 50% on the front. You will just have to mess with it and see what you like.

[TSK]

Set the drag brake to max if you want the strongest dig. But it's really a compromise. Too high a setting can cause the truck to unload once you go off throttle, not enough and the truck can't hold on a incline.

[Krawler23]

I turned up the drag brake to i think 10 (i hate the led light way) and that helped tremendously. Now the rear wheels dont move at all, pretty sweet since i am not used to it actually working haha. Now i just have to try and up the front but its so hard because of all the wire in the way. Thanks for all the help tho.