08-01-2006, 09:21 PM | #1 |
Rock Stacker Join Date: Sep 2005 Location: out there
Posts: 62
| e-flite brushless
has any one tride a e-flite 25 out runner yet? they say it has more power than a .21 nitro engine. with a mamba 25 it could work yes or no?
|
Sponsored Links | |
08-01-2006, 09:23 PM | #2 |
I'm a stupid C U N T! Join Date: Jun 2005 Location: In the Garage!
Posts: 4,307
|
its too big for mounting to a gearbox and it draws way more than 25 amps if i remember right a .21 car motor puts out way more power than a plane engine does too Specs Type: Brushless Outrunner Size: Replacement for 25-size glow engine Bearings or Bushings: Ball Bearings Wire Gauge: 14 Recommended Prop Range: 11x8 to 14x7 Voltage: 12 - 16.8 RPM/Volt (Kv): 870 Resistance (Ri): .03 ohms Idle Current (Io): 2.40A @ 10V Continuous Current: 32A Maximum Burst Current: 44A (30 sec) Cells: 3S-4S Li-Po or 10-14 Ni-MH/Ni-Cd Speed Control: 40A - 45A Brushless Weight: 190g (6.7 oz) Overall Diameter: 35mm (1.4 in) Shaft Diameter: 5mm (.20 in) Overall Length: 54mm (2.1 in) Last edited by slobin3d; 08-01-2006 at 09:46 PM. |
08-02-2006, 07:03 PM | #3 |
owner, Holmes Hobbies LLC Join Date: Nov 2004 Location: Volt up! Gear down!
Posts: 20,290
|
I think those will mount up to a gearbox just fine (been a while since I held one), but the mamba 25 would not quite handle it. 5mm shaft will be the only hurdle.
|
| |