Mamba Max Pro Vs HobbyWing 120a sensored Esc

[EvanSouders]

i want to know whats the better choice i can spend 1 dollar more and get a MMP or save a dollar and get the HobbyWing esc either way im running this motor

HobbyWing XERUN 13.5T 3650-2700KV Sensored Brushless Motor for 1/10 & 1/12 RC Cars ROAR Approved

[DogSpoon]

Seriously? One dollar difference? That makes it tough.

I know a lot of people like the xerun. I had the mini 25A version and there were some things I like about it better than the CC. It seemed to have smoother power delivery, down low for example. I also had great service from Hobbypartz.com.

I'd just get the HW. If enough people do, it'll put pressure on CC to up their game. Not that Czc is bad, competition is just good for the consumers.

[ek9808]

I run a 4.5t in my drifter. Pack after pack and no issues with it. Can't go wrong for the money. Can't say anything for cc but everyone I know says its good stuff.

[benoj]

I've had my mmp since they were released (mine was from the very first batch sold) and have never had an issue with it. It's always been run on 3s lipo with a 21.5 and 18.5t motor in my old losi crawler, 2 30t brushed motors in a moa crawler, the stock 12t Titan in my stampede and the last 6 months a 6.5t in my stampede. The xerun is a decent esc but e castle esc with a castle link has much more adjustability


Sent from my iPad using Tapatalk

[dentonmac]

Originally Posted by EvanSouders

i want to know whats the better choice i can spend 1 dollar more and get a MMP or save a dollar and get the HobbyWing esc either way im running this motor

HobbyWing XERUN 13.5T 3650-2700KV Sensored Brushless Motor for 1/10 & 1/12 RC Cars ROAR Approved

I was running the Xerun 120 in my LCC (may have been the problem) and ran into a reverse issue. There was a delay going from forward to reverse. I tried all the different firmware, and settings. It tried contacting customer service for suggestions, but did not get much response other than 'run no timing'. I also went to their forum on RCTech about it to no response.

The other side of the story, I blew two of them before I said no more...in a crawler.

Xerun truly are great ESCs, and I still run them in all my go-fasts...truly fantastic, solid, and smooth. But I do not mess with them in crawlers anymore.

I now run the MMP in my crawler and it has been fantastic. IMO, crawling is the MMPs wheelhouse. Never had good success with the MMP in go-fasts.

So you know my opinion between the two...in a crawler, Spend the dollar.

I have pretty much run them all (Tekin, Xerun, Speedpassion, MMP, and pretty sure others - just no Novak!)
My opinion, in a go-fast Xerun is better, in a crawler MMP is better.

[Bananaclip]

Im sorry but I only buy castle speed controls!