RCCrawler Forums

Brainstain · 08-25-2006, 02:12 AM

Hopefully this helps some people. The little grey boxes are connectors. The yellow wire is the signal wire. Red is obviously positive and the black in negative. The servo Y should have two female ends and one male end that goes into the reciever. If you want to run a switch just put one between the battery and the Y. If you have any questions, just ask.

Mnster · 08-25-2006, 03:43 AM

How would you do this to run dual servos? The same way or would it over load the reciever?

Brainstain · 08-25-2006, 01:15 PM

Like this for dual servos on different channels.

08-25-2006, 02:12 AM	#1
Brainstain Nope.. Join Date: Aug 2005 Location: Whiteland, Indiana Posts: 1,849	Drew a diagram to run a servo pack Hopefully this helps some people. The little grey boxes are connectors. The yellow wire is the signal wire. Red is obviously positive and the black in negative. The servo Y should have two female ends and one male end that goes into the reciever. If you want to run a switch just put one between the battery and the Y. If you have any questions, just ask. Last edited by Brainstain; 08-25-2006 at 02:14 AM.

08-25-2006, 03:43 AM	#2
Mnster MWRCA'er Join Date: Apr 2004 Location: Machesney Park IL Posts: 3,995	How would you do this to run dual servos? The same way or would it over load the reciever?

08-25-2006, 01:15 PM	#3
Brainstain Nope.. Join Date: Aug 2005 Location: Whiteland, Indiana Posts: 1,849	Like this for dual servos on different channels.

Sponsored Links

RCCrawler Forums

Thread: Drew a diagram to run a servo pack