11-29-2006, 08:33 PM | #1 |
Newbie Join Date: Feb 2006 Location: West salem
Posts: 44
| 5mm pinions http://www.modelelectronicscorp.com/ has anyone ordered from this company? I need a 48p 28T pinion for a 5mm shaft to make the output drives for my TLT tranny.. $13 seems a little steep but then again its just one part and the rest of the tranny only cost me $20.. also, If anyone might know where I can get a 2in long 5mm shaft? and various sizes of bearings with collars? The shaft I have is Cast Aluminum and the tranny is all bronze bushings which I am sure I will have to replace after a season. like I said, $20 transmission. |
Sponsored Links | |
11-29-2006, 10:53 PM | #2 |
owner, Holmes Hobbies LLC Join Date: Nov 2004 Location: Volt up! Gear down!
Posts: 20,290
|
Go to https://sdp-si.com/eStore/ for lots of little stuff. I recommend drill blanks for your shaft that you want. I have never ordered from them, but I imagine that thier 5mm pinions are just drilled in house. RC4wd is releasing 5mm pinions next week as well if you want to support a crawler vendor. |
| |