Winch install on bomber
 

So I'm wanting to install a winch on my bomber. Possibly one of the rc4wd ones but not set in stone on that. Been doing a lot of reading on how to wire it in and what not. Kinda more lost now then before I started.

I have the tactic e channel controller, but am I correct that the reciever isn't going to put full battery voltage to the winch if hooked up that way? Put a winch on my kids wraith using the wireless controller and remote but wanted to try and run mine using the buttons on the controller already.

Any help is appreciated

Re: Winch install on bomber
 

Maybe I can help.
First though, I am not sure what this is: "tactic e channel controller"
Maybe a link or a picture would help, but I assume it is the remote control transmitter that you have.
The thing to find out is if there is a third channel and if it is a two or three position channel. Next you need to decide on a winch controller.
To put full battery voltage to the winch, one of these winch controllers will work:
These two are for a three position channel, but I can make them for a two position channel as well:

http://www.rccrawler.com/forum/vendo...ml#post4754752
Or this one which is functionally the same, but takes up less space:
http://www.rccrawler.com/forum/vendo...ontroller.html

If you want a key fob type remote, then this will work:
http://www.rccrawler.com/forum/vendo...ml#post5238066

Hope that helps!
Al

Re: Winch install on bomber
 

Sorry was suppose to say 3 channel tactic