03-07-2021, 05:30 PM | #1 |
Rock Stacker Join Date: Jul 2020 Location: USA
Posts: 51
| Rx4 problems again!
Hey y’all. Went to take my TF2 out and I got no throttle at all. Running an rx4, sensored brushless 1800kv, protek 370 btl servo, 5 channel spektrum receiver with the Dx5 rugged. When I turned it on I had to bind the receiver for some reason, and after re-binding I have steering, and my shift servo is working fine. Did a calibration, and the quick setup with the esc over and over. Looks like the 3 lights to the left nearest the mode button are flashing simultaneously and won’t stop. Just seeing if anyone had any ideas before I start unwireing this thing. Checked the sensor plug and all soldered connections. Ran perfect last time out and now this? Thanks for any help. Also, tried to go in on the Hotwire and nothin helped.
|
Sponsored Links | |
03-08-2021, 07:05 PM | #2 |
Rock Stacker Join Date: Jul 2020 Location: USA
Posts: 51
| Re: Rx4 problems again!
Does any know of problems with the Hotwire programmer? When I tried to program my ultra to run a couple 2s lipos down it lost calibration and was going forward and reverse erratically. I did a quick setup with the esc and it fixed my ultra. When I bind to the Hotwire 3.0 it says “demo” and a bunch of zeros and x’s and not Rx4 like it used to. Thinking it may not be programming my TF2 for 2s?
|
Rx4 problems again! - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
RX4 Calibration !!! NO Reverse | jeepster73 | Electronics | 5 | 03-02-2020 02:23 PM |
Tekin RX4 | Odd-M | Electronics | 48 | 03-12-2017 06:49 PM |
help with rx4 cha-3-4 | Dfrog | Electronics | 0 | 12-26-2010 09:16 PM |
| |