|
| LinkBack | Thread Tools | Display Modes |
08-15-2020, 09:18 AM | #1 |
Quarry Creeper Join Date: Dec 2009 Location: Strafford, NH
Posts: 473
| Reverse throw of 1 position on 3 position SW
My TX has a 3 position switch Down is negative throw Middle is neutral Up is positive throw Is there a device or way to change the throw on one side/channel of the switch? I would like the servo to go the same direction on both positions of the switch. I am thinking I need something on the signal wire. Positive signal positive throw Negative signal positive throw I have a Radiolink TX and a TRX6 that I am mixing the 2 locker channels to one switch. The mix is working, down position CH4 one Servo has throw, up position both servos have throw but I need to reverse the throw on CH4 |
Sponsored Links | |
08-15-2020, 10:13 AM | #2 |
Gold Star Baby! Join Date: Dec 2017 Location: Las Vegas
Posts: 2,554
| Re: Reverse throw of 1 position on 3 position SW
Not sure I’m completely following, but maybe something like this? https://www.ebay.com/itm/High-Voltag...oAAOSwIWVY-XLy |
08-15-2020, 05:41 PM | #3 |
I wanna be Dave Join Date: Jul 2005 Location: North Idaho
Posts: 3,648
| Re: Reverse throw of 1 position on 3 position SW
Sounds like you need the Traxxas T-loc module.
|
08-16-2020, 04:56 AM | #4 |
Quarry Creeper Join Date: Dec 2009 Location: Strafford, NH
Posts: 473
| Re: Reverse throw of 1 position on 3 position SW
Thanks guys. I have been searching and play with this for 2 weeks.
|
08-17-2020, 06:05 AM | #5 |
I wanna be Dave Join Date: May 2007 Location: Vancouver, BC
Posts: 2,379
| Re: Reverse throw of 1 position on 3 position SW
I make an End-Point adjuster for a two-position channel: https://www.freewebstore.org/heyok-p..._18344974.aspx It's not shown, but I can also make it for a three-position channel. It would have one more pot for setting the center position. So each position of your three-position channel would have the effect of choosing what pot sets the servo position. That would do what you are looking for. Let me know if you want to explore this further and I will get it going for you. Thanks, Al |
Reverse throw of 1 position on 3 position SW - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Convert a TWO position channel to a THREE position channel! | heyok | Vendors Electronics | 3 | 11-24-2015 05:42 AM |
truck running in reverse with trigger in neutral position | mudrinner4ever | Electronics | 9 | 10-30-2011 07:23 PM |
2 position and 3 position switches?? | Laker67 | Electronics | 8 | 09-09-2010 09:49 PM |
DX6, replacing the 2 position gear and aux switches for 3 position? | 666 | Electronics | 10 | 04-30-2007 11:23 PM |
| |