| |
10-05-2020, 04:53 AM
| #1 |
| Rock Stacker Join Date: Dec 2019 Location: Calabogie, Ontario, Canada
Posts: 74
|  Spectrum STX3 question
Hi folks. My buddy was trying to set up his Spectrum STX3 radio in his truck and he is having a hang of a time to have it bind. We both followed the instructions in the manual but all the Rx would do was blink. The Rx is the SRX300 that came with the radio. Would anyone be able to guide us on this problem? Any advise or instructions would be great and appreciated. Regards Tar  |
|  |
| Sponsored Links | |
| | |
|
10-05-2020, 07:49 AM
| #2 |
| Quarry Creeper Join Date: Dec 2013 Location: The Garden State, North of I-80
Posts: 439
| Re: Spectrum STX3 question
This is from my airplane experience with Spektrum. Move the Tx further away when you bind. If you can't, put the Tx behind your body, e.g., use your body as a separator. Sometimes when you are too close, the signal swamps the Rx. |
|
| |
|
10-06-2020, 04:06 AM
| #3 |
| Rock Stacker Join Date: Dec 2019 Location: Calabogie, Ontario, Canada
Posts: 74
| Re: Spectrum STX3 question
Hi folks. Thank you Kingmeow for the info. I will pass this info on to my buddy and he can give this way a try. I hope it works. thanks again. Regards Tar |
|
| |
 |
Spectrum STX3 question - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| NEW Spektrum STX3 3-Channel 2.4 GHz FHSS Radio System - In Stock! | RPP Hobby | RPP Hobby | 0 | 10-14-2019 10:37 AM |
| Spectrum DX3C binding question | 2-shot | Electronics | 3 | 05-12-2012 07:21 PM |
| spectrum dx 3.0 question | intheworks | Electronics | 10 | 02-26-2009 01:07 AM |
| Spectrum Question | 8500lbs | Electronics | 2 | 08-15-2007 08:07 PM |
| |
Linear Mode
