Hacked flysky radio programming help

[bro_die]

I've been reading and reading and I still can't figure this hack future. I'm using a gt3c hacked and I'm trying to control a winch for my rig. Anybody mastered how to program this radio. Thanks in advance.

Sent from my SAMSUNG-SM-G900A using Tapatalk

[ADlBOO]

What winch and winch control are you using? What exactly is the problem?

[losikid]

Have you tried this?
http://overkillrc.com/GT3X-Firmware/...lp%20cards.pdf

[drzoo2]

Assuming the winch controller is looking for endpoints with "0" as off......

To use the CH3 TRIM to momentary toggle between -100 <--> 0 <--> +100 by remapping the the CH3 trim switch (the switch above the CH3 toggle button).

Highlight REV and Long press the ENTER button. (it will flash)
Jog to "3"
"Enter"
Jog to CH3
"ENTER"
Jog to BMO
"ENTER
REO
"ENTER"
PV0
"ENTER
"END" BUTTON twice. (make sure nothing is highlighted. 
When something is highlighted "special" functions will not work)

Holding back the CH3 TRIM switch will momentarily set the endpoint to -100. Pushing forward will move it to +100. Doing nothing leaves it at 0

EDIT: I use my own winch this way but also have the TH TRIM buttons mapped to stay at an end point so I don't have to hold a button to spool.

[losikid]

Originally Posted by drzoo2

Assuming the winch controller is looking for endpoints with "0" as off......

To use the CH3 TRIM to momentary toggle between -100 <--> 0 <--> +100 by remapping the the CH3 trim switch (the switch above the CH3 toggle button).

Highlight REV and Long press it. (it will flash)
Jog to "3"
"Enter"
Jog to CH3
"ENTER"
Jog to BMO
"ENTER
REO
"ENTER"
PV0
"ENTER
"END" BUTTON twice. (make sure nothing is highlighted. When something is highlighted "special" functions will not work)

Holding back the CH3 TRIM switch will momentarily set the endpoint to -100. Pushing forward will move it to +100. Doing nothing leaves it at 0

Those settings should work.

But I would like to note. Those settings aren't adjusting the endpoints in the radio, they are actually moving the channel postion to the endpoint.

[drzoo2]

Originally Posted by losikid

Those settings should work.

But I would like to note. Those settings aren't adjusting the endpoints in the radio, they are actually moving the channel postion to the endpoint.

Good point. I'm making the assumption that the endpoints on a winch controller don't matter unless it also controls speed, at which case it would be full forward or reverse.

[bro_die]

Alriggt guys thanks for the help. It works wooohoo. One more queation. How to you reverse the steering and throttle?

Sent from my SAMSUNG-SM-G900A using Tapatalk

[drzoo2]

Thats under the normal reverse setting. Quick press.