| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
11-20-2007, 08:43 PM
| #1 |
| RCC Addict Join Date: May 2006 Location: California
Posts: 1,361
|  How to install switch for winch?
I have got a winch all wired up and it wont stop moving. I know about the pot thing, and it will stop moving, but next time i turn the truck on, it moves again. So i want to install a on/off switch to the winch. I dont really know which wires to solder to the switch and where they go. If anyone can tell me or has any pics to show how to solder the switch to cut the power to the servo that would be awesome. I'm using a tq3 btw. Thanks for any help!
|
|  |
| Sponsored Links | |
| | |
|
11-20-2007, 09:46 PM
| #2 |
| owner, Holmes Hobbies LLC   Join Date: Nov 2004 Location: Volt up! Gear down!
Posts: 20,290
|
Just cut the midde (normally red) wire, and install an on/off between the two ends.
|
|
| |
|
11-20-2007, 09:53 PM
| #3 |
| RCC Addict Join Date: May 2006 Location: California
Posts: 1,361
|
Ok cool. Thanks a lot!
|
|
| |
|
| |
Linear Mode
