| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
08-28-2017, 10:15 PM
| #1 |
| Newbie Join Date: May 2017 Location: MKE
Posts: 39
|  Gear reduction, axles, transmissions, oh my
After going from the stock axles on my ECX Barrage to MST MSA axles, I noticed the two have different gear reductions. The Barrage axles are either 2:1 or 4:1, and my MSA axles are 1:1. What would be the easiest way to fix this? I am running the standard 370 size motor, so I can't use the 4:1 RC4WD 540 motor gear reducer...any help would be appreciated! |
|  |
| Sponsored Links | |
| | |
|
09-04-2017, 10:23 PM
| #2 |
| RCC Addict Join Date: Aug 2013 Location: Missoula
Posts: 1,346
| Re: Gear reduction, axles, transmissions, oh my
MSA axle looks like 2.4:1? ECX looks like 38:14, 2.71:1. That's really close. Just a bit slower on the motor pinion and you'll be good. 2 teeth down or so. |
|
| |
|
Gear reduction, axles, transmissions, oh my - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Why is there an idler gear in transmissions? | Maggster | Newbie General | 5 | 10-09-2012 01:51 PM |
| homemade transmissions/gearboxes/reduction units. Post them here. | BrentH | General Crawlers | 2 | 01-10-2011 06:25 AM |
| Tamiya Gear Head Gear reduction ??? | TwistedXT | General Crawlers | 4 | 08-06-2007 12:33 AM |
| Can you use old axles for gear reduction? | clodman | General Crawlers | 10 | 04-27-2006 08:47 AM |
| GD-600 gear reduction on clod axles | aubie | Tamiya Clod Buster | 27 | 08-30-2004 03:58 PM |
| |
Linear Mode
