02-22-2012, 01:55 PM | #1 |
Quarry Creeper Join Date: Jul 2007 Location: Sierra Foothills
Posts: 201
| Servo Horn
I am so frustrated with breaking the stock servo horns for the MCRC. The spline on the stock servo is some odd ball size. Does anybody know of a place to get aluminum servo horns or a design that won't break? I can't afford to get all new Hi-Tech servos at this time. Thank you.
|
Sponsored Links | |
02-22-2012, 02:40 PM | #2 |
Rock Crawler Join Date: Oct 2011 Location: Lexington
Posts: 503
| Re: Servo Horn
I've been using an E-Flite S75. It's $14 and even with MiClaws I haven't broken it yet. Much better than the Losi servo and cheaper. The horn is also a lot stronger.
|
02-22-2012, 03:15 PM | #3 |
Rock Crawler Join Date: Nov 2008 Location: Nor*Cal Cameronpark
Posts: 510
| Re: Servo Horn
Rework the stock horn with some aluminum Its damn near bulletproof now! |
02-22-2012, 08:33 PM | #4 |
Rock Crawler Join Date: Oct 2011 Location: Lexington
Posts: 503
| Re: Servo Horn
Actually if you're good with epoxy, you can just coat the thing with some 5-minute epoxy (wait until it starts to tack up) and you could do a pretty good bandaid fix. Then when you have the money for the HiTecs or the Turnigys, you can swap over.
|
02-23-2012, 10:26 PM | #5 |
Newbie Join Date: Jan 2012 Location: jackson
Posts: 47
| Re: Servo Horn
Beaters is dead on, Iv had good results w/epoxy & ca?
|
Servo Horn - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Which servo horn for traxxas 2055 servo? | Magnus JE | Newbie General | 3 | 03-14-2007 12:42 AM |
metal gear servo, servo horn screws... M2, 4-40, M3??? | dieselfuel | General Crawlers | 7 | 12-25-2006 07:00 PM |
Aluminum servo horn for Bluebird servo | AdamF | Electronics | 2 | 01-21-2005 08:36 PM |
| |