| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
12-16-2006, 08:05 PM
| #1 |
| Newbie Join Date: Dec 2006 Location: columbia
Posts: 34
|  motor suggestions also!!! integy 55T? Im building a clod tuber with an EVX esc ans was wondering if Integy lathe 55t's would be best....i will be running the 6.75" clod swamp dawgs |
|  |
| Sponsored Links | |
| | |
|
12-16-2006, 08:29 PM
| #2 |
| Rock Crawler Join Date: Aug 2006 Location: On the trail
Posts: 671
| |
|
| |
|
12-16-2006, 08:43 PM
| #3 |
| RCC Addict Join Date: Dec 2004 Location: Central NY
Posts: 1,988
| Depends on what you want. If you want a little more speed then 55t is good. If you want more power than anything, 67t or 75t would be best. |
|
| |
|
12-17-2006, 02:42 AM
| #4 |
| Newbie Join Date: Nov 2005 Location: Vancouver
Posts: 34
| Check out the Axioms. Tammies hobbies in the vendor section has them. |
|
| |
|
12-17-2006, 11:10 AM
| #5 |
| Newbie Join Date: Dec 2006 Location: columbia
Posts: 34
| well too late I guess i ordered 2 integy 55t's but i almost went with the 75t, i can always change up later |
|
| |
|
| Thread Tools | |
| Display Modes | |
| |
Linear Mode
