All-Pro Expedition Pack Rack Build While waiting for my BPC Chassis to be built i decided to give brazing a go as i will need to do a rear bumper and i am sure a bunch of other things. I am still collecting materials (Safe Silv 45, MAP torch) but was able to get some 1/4 brake-line and angle iron. I am trying to make a copy of a All-Pro Expedition Series Pack Rack https://www.allprooffroad.com/tech-i...coma-pack-rack. I say trying because this is my 1st attempt at bending brake line and brazing. I will practice brazing before final assembly. I had a hard time figuring out the bend degrees, lengths, where to start the bend etc. Basically learning as i went. So far just the hoops are bent. Following the cab lines was the hardest part. I wouldn't put it on my real truck but i am happy for my 1st attempt. I can only get better with more practice right. My build thread is here http://www.rccrawler.com/forum/large...ack-build.html but below is a picture of it at this point. http://i1273.photobucket.com/albums/...pspm9khsa0.jpg |
All times are GMT -6. The time now is 03:03 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com