|
| LinkBack | Thread Tools | Display Modes |
09-14-2013, 12:39 AM | #1 |
Newbie Join Date: Apr 2010 Location: Australia
Posts: 31
| 1/8 scale Custom Crawler
Ok guy's i have been thinking about doing this for a long time ........ This was my old Nitro Truggy that was turned into Brushless and now it's going to be transformed into a Big Crawler, im not sure on the wheel base yet and im not sure where im going to go with this so it will just evolve along the way..... I will need a transmission and some drive shafts that will fit the 8mm outputs on the diff...... I'll make the skid and links out of Delrin..... This is what i have to start with Last edited by icrawl2; 09-14-2013 at 12:41 AM. Reason: fixed mistakes |
Sponsored Links | |
09-14-2013, 12:43 AM | #2 |
Newbie Join Date: Apr 2010 Location: Australia
Posts: 31
| Re: 1/8 scale Custom Crawler
This is what's left to work with, i need to lock up both diffs.... Locked up the front arms on a slight angle to give the center diff some ground clearance, also swapped over the steering blocks so the steering links will be out in front, i might try BTA later..... |
09-14-2013, 12:47 AM | #3 |
Newbie Join Date: Apr 2010 Location: Australia
Posts: 31
| Re: 1/8 scale Custom Crawler
Just trying to work out the best wheel base This is at 15 inches And this is at 17 inches Might go with 16 inches |
09-14-2013, 09:20 AM | #4 |
Rock Stacker Join Date: Apr 2013 Location: San Diego
Posts: 79
| Re: 1/8 scale Custom Crawler
very interested to see where this going! |
09-14-2013, 07:38 PM | #5 |
Newbie Join Date: Apr 2010 Location: Australia
Posts: 31
| Re: 1/8 scale Custom Crawler
Just need to pick up a tranny, not sure what to get yet either..... might just use a Axial scx10
|
11-29-2013, 07:47 AM | #6 |
Gold Star Baby! Join Date: Jul 2011 Location: Warren, MI
Posts: 269
| Re: 1/8 scale Custom Crawler
a summit 2 speed would be sweet.
|
| |