|
| LinkBack | Thread Tools | Display Modes |
03-07-2009, 12:05 PM | #1 |
RCC Addict Join Date: Jan 2008 Location: www.rccrawler.com
Posts: 1,113
| Anyone Using The Hot Racing Clod Knuckles?
Are they any good? Will most likely use them without CVDs in a rock racer basher brushless clod so all I need is strength to withstand high jumps etc... I run JP knuckles in my crawler but wanted to try something cheaper in this build ... Any info appreciated |
Sponsored Links | |
03-09-2009, 02:06 AM | #2 |
Rock Crawler Join Date: Dec 2008 Location: Displacement
Posts: 525
|
I'm currently using the hr knuckles and axle tubes on my clod for the past nine months and they are holding up really well. My trucks seen some three foot falls to hard ground with no breakage. Can't really compare them to others out there cause I haven't owned any others besides stockers. I can post some pics if needed. |
03-09-2009, 07:35 AM | #3 | |
RCC Addict Join Date: Jan 2008 Location: www.rccrawler.com
Posts: 1,113
| Quote:
| |
03-09-2009, 05:43 PM | #4 |
Rock Crawler Join Date: Dec 2008 Location: Displacement
Posts: 525
|
I'm running the hot racing axletubes with stock axle shafts and a rcp diff locker.
|
03-09-2009, 08:53 PM | #5 |
RCC Addict Join Date: Jan 2008 Location: www.rccrawler.com
Posts: 1,113
| |
03-09-2009, 09:03 PM | #6 |
Newbie Join Date: Feb 2009 Location: Randolph
Posts: 26
| |
03-10-2009, 12:48 PM | #7 |
I wanna be Dave Join Date: Aug 2007 Location: JERSEY BOONDOCKS
Posts: 3,360
|
I run the tubes and knuckles...The tubes are awesome! The knuckles are OK...I have bent on of the arms before. granted, it was after a big fall and it didnt break...it just bent...i bent it back and its been fine since. That was a long time ago too. All in all...I like the combo...it was relatively cheap and works pretty good. |
04-24-2009, 03:26 PM | #8 |
Rock Crawler Join Date: Jan 2006 Location: Nebiru, OuterSpace
Posts: 500
|
are those TTR CVD's with HR tubes/knuckles? How are you getting them to fit... my TTR CVD's seem too wide/long and the holes on knuckle and axles "C" don't line up... ??? |
04-25-2009, 01:59 AM | #9 |
I wanna be Dave Join Date: Sep 2005 Location: USA
Posts: 11,196
|
Same Tubes and Knuckles here with TTR CVD's. Everything just bolted right up.. Was running this Combo for over 2 yrs. Not one issue with bending, Breaking or fitment issue.. |
04-27-2009, 09:20 AM | #10 |
I wanna be Dave Join Date: Aug 2007 Location: JERSEY BOONDOCKS
Posts: 3,360
|
X2...they are stock clod replacement parts. all the dimensions should be the same. Are you sure the cvd's are sitting properly into the center locker? |
| |