RCCrawler Forums - A new Project. Rock Rider Chassis w/Dig and Portals

Page 4 of 4

Show 40 post(s) from this thread on one page

RCCrawler Forums (http://www.rccrawler.com/forum/)

- Tamiya TLT Crawlers (http://www.rccrawler.com/forum/tamiya-tlt-crawlers/)

- - A new Project. Rock Rider Chassis w/Dig and Portals (http://www.rccrawler.com/forum/tamiya-tlt-crawlers/89955-new-project-rock-rider-chassis-w-dig-portals.html)

Racer4Life

12-10-2007 09:39 AM

Thanks JC.

Quote:

Originally Posted by F250 (Post 955948)

How much ground clearance do the portals add?

Here are a few photo's I took a while back when I first got the second version portals.

Here it is without the portals.
http://i133.photobucket.com/albums/q...-2-07_3673.jpg

Here it is shown with the portals.
http://i133.photobucket.com/albums/q...-2-07_3675.jpg

sLeigh_P

12-10-2007 10:44 AM

Nice job Racer.

I'm getting 10 mm (.394) offset from axle center line on my portals. Did you rebuild the portals with the hardened gear set or exchange?

Racer4Life

12-10-2007 11:54 AM

Quote:

Originally Posted by sLeigh_P (Post 957603)

Nice job Racer.

I'm getting 10 mm (.394) offset from axle center line on my portals. Did you rebuild the portals with the hardened gear set or exchange?

I have not received the replacement hardned gears yet. These were the second version. The new hardned one's are the third revision.

F250	12-10-2007 01:51 PM

Nice bit of added clearence.

bob1961

03-27-2008 11:08 PM

very nice rock rider chassis build....looks like it has a lot of promise "thumbsup" ......................bob

....

All times are GMT -6. The time now is 10:51 AM.

Page 4 of 4

Show 40 post(s) from this thread on one page