rear shaft dimensions

[jebster]

for a project I'm working on (winch using lcc spool/worm gear) I need to run a short shaft into the spool to drive my spindle. does anyone have dimensions on a standard lcc rear driveshaft? looking to find out the width (flat side to flat side) of the square tang that engages the spool and the diameter of the narrowed section of the shaft between the tang area and the outer bearing retainer. I'm guessing the shaft diameter is 5mm but I want to confirm.

any help is appreciated.

[JENS]

Originally Posted by jebster

for a project I'm working on (winch using lcc spool/worm gear) I need to run a short shaft into the spool to drive my spindle. does anyone have dimensions on a standard lcc rear driveshaft? looking to find out the width (flat side to flat side) of the square tang that engages the spool and the diameter of the narrowed section of the shaft between the tang area and the outer bearing retainer. I'm guessing the shaft diameter is 5mm but I want to confirm.

any help is appreciated.

Tang,-flat side to flat side: 4,5 mm
Narrowed section closest to tang: 4,5 mm
Outer shaft diameter,-where the bearing is: 5 mm

[jebster]

Originally Posted by JENS

Tang,-flat side to flat side: 4,5 mm
Narrowed section closest to tang: 4,5 mm
Outer shaft diameter,-where the bearing is: 5 mm

thanks for the info. and it looks like I have to find something custom made. with the narrowed section being 4.5mm it won't work for me (needed that to be 5mm).