|
| LinkBack | Thread Tools | Display Modes |
03-08-2014, 09:28 PM | #1 |
I wanna be Dave Join Date: May 2006 Location: FOUR 8 OH
Posts: 4,913
| Aluminum bars and strips
So I need to make up a couple of brackets and trying to source some aluminum strips. What I'm wondering is, what would be the thinnest I should get for mounting a body to? I'm planning on shoegooing some magnets to the body and to the aluminum for mounting. Anyone got a source for those little magnets? |
Sponsored Links | |
03-09-2014, 12:12 AM | #2 |
RCC Addict Join Date: Jun 2011 Location: Gilbert, AZ
Posts: 1,634
| Re: Aluminum bars and strips
Woodcraft has a good selection of rare earth magnets. At least they did when I got mine there quite some time ago. Arizona Ave and Elliot( I believe). I would think Ace would have some also. 0.063" should be thick enough, might even get away with 0.040. I used some thicker stuff in the past and it was overkill for mine.
|
03-09-2014, 03:55 AM | #3 |
Quarry Creeper Join Date: May 2009 Location: India
Posts: 365
| Re: Aluminum bars and strips
For mounting brackets I think 16 Gauge (0.0508 " thick) aluminum will be right. A little thinner and I feel it will break by fatigue and weight. Are the brackets going to be right angled in shape? |
03-09-2014, 09:44 AM | #4 |
I wanna be Dave Join Date: Aug 2006 Location: under a rock and a hard place
Posts: 5,443
| Re: Aluminum bars and strips
Harbor frieght has then for cheap if there is one in your area
|
03-09-2014, 10:11 AM | #5 |
I wanna be Dave Join Date: May 2006 Location: FOUR 8 OH
Posts: 4,913
| Re: Aluminum bars and strips
Thanks guys - there is a Harbor Freight not too far from me, as well as an Ace. |
03-09-2014, 02:13 PM | #6 |
RCC Addict Join Date: Jun 2011 Location: Gilbert, AZ
Posts: 1,634
| Re: Aluminum bars and strips
Ace will have a small selection of aluminum also.
|
Aluminum bars and strips - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Slick Strips | Norton | General Crawlers | 4 | 03-09-2013 12:19 PM |
Aluminum strips | neoakaj | Scale Accessories | 12 | 09-22-2011 12:15 AM |
Cutting Strips Of Sheet Metal | @tw!ll | Tools, and Procedures | 3 | 09-17-2010 05:42 PM |
| |