RCCrawler Forums
Page 7 of 7 « First 23456 7
Show 40 post(s) from this thread on one page

RCCrawler Forums (http://www.rccrawler.com/forum/)
-   Vaterra Ascender (http://www.rccrawler.com/forum/vaterra-ascender/)
-   -   Things to know before you start building your Ascender... (http://www.rccrawler.com/forum/vaterra-ascender/507799-things-know-before-you-start-building-your-ascender.html)

Schs2013 02-03-2022 01:40 AM
Re: Things to know before you start building your Ascender...
 
Quote:
Originally Posted by meatmonkey (Post 6106863)
Unthread the Ballstud from the servo horn and put a small spacer, or thin 3mm nut, on the stud then reinstall it into the horn. This will lower the pivot point a couple mm without lowering the entire servo.

Thank you for the suggestion. I will try that when the new servo gets installed


Sent from my iPhone using Tapatalk

Schs2013 02-14-2022 06:19 PM
Re: Things to know before you start building your Ascender...
 
Quote:
Originally Posted by meatmonkey (Post 6106863)
Unthread the Ballstud from the servo horn and put a small spacer, or thin 3mm nut, on the stud then reinstall it into the horn. This will lower the pivot point a couple mm without lowering the entire servo.
So i used about 2mm space and set up a different rodend that allows for a pass through screw. And i did lower the servo mounting to the bottom side of the servo mount to help lower it. Thank you for your you're suggestion again meat monkey it helped me out a lot.

Sent from my FRD-L14 using Tapatalk


All times are GMT -6. The time now is 01:49 PM.
Page 7 of 7 « First 23456 7
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com