RCCrawler Forums

BJK · 10-12-2010, 10:41 PM

When do you guys want to gtg again and lets go somewhere new. Ideas?

Hyde802 · 10-13-2010, 06:33 AM

Im free most weekends, and get out of work around 5. Im still waiting on parts, so im currently front wheel drive only, but hopefully they come in before the weekend.

BIKETROLL · 10-13-2010, 06:13 PM

I can't saturday,but possibly sunday.

Hyde802 · 10-13-2010, 07:58 PM

booked sunday. workin on the 1:1

BJK · 10-23-2010, 08:42 AM

anyone up to go tomorrow afternoon

Hyde802 · 10-26-2010, 06:42 AM

Im free this weekend

Hyde802 · 10-31-2010, 01:36 PM

Went to the Horn of the moon road today for the first time. Had a blast. Realized my little 4.5 inch tall tires just arnt going to cut it. So I just placed an order from ckrc for some new rovers

BJK · 10-31-2010, 09:57 PM

I went to the Woodbury quarries and found a spot that is great for scale rigs, it is a big waterfall with a little water that flows down an old road had a blast. Good thing I am waterproof because a few spots are pretty deep.

Hyde802 · 11-14-2010, 03:04 PM

I found a sweet spot in Johnson today. Its called dogs head, there is a large section of rock that the river has shaped into some very fun lines. Would be very good for scalers. And there is the constant danger of your rig getting wet. Its pretty exciting. I killed an hour there today easy, and ill be there next sat with full bats.

BJK · 12-16-2010, 11:41 PM

What is everyone up too? Anyone been playin in the snow? Santa being you all any crawler stuff? Pretty sure I am getting a winch and some 2.2 TSL's. I have been working on the truck a bit andd added some bed side, What do you think?

Hyde802 · 12-21-2010, 01:32 PM

I broke mine. rolled it and it ended up side down in a near freezing puddle for about 5 sec ant the above mentioned spot Haha. Long story short, I need new electronics. Ill get them after this holiday rush. Any body have a some nice indoor spots to crawl now that its cold? I brought some rocks inside my appt, but its super small. Hope to have the cralwer up and going again by end of jan. All my money has been going in to my 1:1s.

Edit: Im looking for a dual motor ESC and RX if anyone has one? Deff does not have to be fancy, just has to work.

Hyde802 · 01-04-2011, 09:44 PM

Just ordered a new ESC and a rx/tx. Should be good to go by next weekend.

Excited to climb some snow banks!

BJK · 01-04-2011, 10:58 PM

What did you order?

Hyde802 · 01-05-2011, 08:05 AM

I got a RC4WD Outcry dual motor esc with fan and bec, accidentally shipped it to my parents house, Im picking it up this weekend.

And just sent payment for a RC4WD Offroader 3ch 2.4 radio that I found on the classifieds here, should be here some time next week.

Hyde802 · 01-08-2011, 10:36 PM

Alright! Im back up and running! Still using the old radio, couldant get this new one to work...yet. But it seels to all be running good.

Crawl on.

Edit: New radio is good! Everything is working as it should. However, I dropped one of my battery packs on the ground and broke a connection in it. Anyone good at soldering battery packs?

opie · 01-10-2011, 06:31 AM

I just got my new trail honcho. I have it mostly built now but I'm still aways from having it done. But my AX10 it ready to go anytime. I wish there was an indoor crawling area. I really want to go crawling.

Hyde802 · 01-12-2011, 02:10 PM

Indoor crawling would be nice. I have a few rocks stacked in my living room, but nothing to write home about.

Tonight Im going to try and water proof my setup so I can run it in the snow without worrying. Also going to look into studding the stock tires for some ice crawling fun.

Edit: This is my answer to cabin fever! Flash light duct taped to the hood, electronics in a ziplock, Lets do some snow wheelin!

BJK · 01-13-2011, 01:06 AM

I have been putting mine outside the back door closing the door and driving while looking out the window.

Hyde802 · 01-14-2011, 06:51 AM

Haha. Yup, thats what the flash light is for. So I can go beyond the outside light and still know where the truck is!

10-12-2010, 10:41 PM	#1
BJK Newbie Join Date: Mar 2009 Location: woodbury Posts: 38	What next When do you guys want to gtg again and lets go somewhere new. Ideas?

12-21-2010, 01:32 PM	#11
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	I broke mine. rolled it and it ended up side down in a near freezing puddle for about 5 sec ant the above mentioned spot Haha. Long story short, I need new electronics. Ill get them after this holiday rush. Any body have a some nice indoor spots to crawl now that its cold? I brought some rocks inside my appt, but its super small. Hope to have the cralwer up and going again by end of jan. All my money has been going in to my 1:1s. Edit: Im looking for a dual motor ESC and RX if anyone has one? Deff does not have to be fancy, just has to work. Last edited by Hyde802; 01-05-2011 at 08:06 AM.

01-08-2011, 10:36 PM	#15
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	Alright! Im back up and running! Still using the old radio, couldant get this new one to work...yet. But it seels to all be running good. Crawl on. Edit: New radio is good! Everything is working as it should. However, I dropped one of my battery packs on the ground and broke a connection in it. Anyone good at soldering battery packs? Last edited by Hyde802; 01-11-2011 at 01:20 PM.

01-12-2011, 02:10 PM	#17
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	Indoor crawling would be nice. I have a few rocks stacked in my living room, but nothing to write home about. Tonight Im going to try and water proof my setup so I can run it in the snow without worrying. Also going to look into studding the stock tires for some ice crawling fun. Edit: This is my answer to cabin fever! Flash light duct taped to the hood, electronics in a ziplock, Lets do some snow wheelin! Last edited by Hyde802; 01-12-2011 at 08:49 PM.

10-13-2010, 06:33 AM	#2
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	Im free most weekends, and get out of work around 5. Im still waiting on parts, so im currently front wheel drive only, but hopefully they come in before the weekend.

10-13-2010, 06:13 PM	#3
BIKETROLL Newbie Join Date: Oct 2005 Location: MORETOWN Posts: 33	I can't saturday,but possibly sunday.

10-13-2010, 07:58 PM	#4
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	booked sunday. workin on the 1:1

10-23-2010, 08:42 AM	#5
BJK Newbie Join Date: Mar 2009 Location: woodbury Posts: 38	anyone up to go tomorrow afternoon

10-26-2010, 06:42 AM	#6
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	Im free this weekend

10-31-2010, 01:36 PM	#7
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	Went to the Horn of the moon road today for the first time. Had a blast. Realized my little 4.5 inch tall tires just arnt going to cut it. So I just placed an order from ckrc for some new rovers

10-31-2010, 09:57 PM	#8
BJK Newbie Join Date: Mar 2009 Location: woodbury Posts: 38	I went to the Woodbury quarries and found a spot that is great for scale rigs, it is a big waterfall with a little water that flows down an old road had a blast. Good thing I am waterproof because a few spots are pretty deep.

11-14-2010, 03:04 PM	#9
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	I found a sweet spot in Johnson today. Its called dogs head, there is a large section of rock that the river has shaped into some very fun lines. Would be very good for scalers. And there is the constant danger of your rig getting wet. Its pretty exciting. I killed an hour there today easy, and ill be there next sat with full bats.

12-16-2010, 11:41 PM	#10
BJK Newbie Join Date: Mar 2009 Location: woodbury Posts: 38	What is everyone up too? Anyone been playin in the snow? Santa being you all any crawler stuff? Pretty sure I am getting a winch and some 2.2 TSL's. I have been working on the truck a bit andd added some bed side, What do you think?

01-04-2011, 09:44 PM	#12
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	Just ordered a new ESC and a rx/tx. Should be good to go by next weekend. Excited to climb some snow banks!

Sponsored Links

01-04-2011, 10:58 PM	#13
BJK Newbie Join Date: Mar 2009 Location: woodbury Posts: 38	What did you order?

01-05-2011, 08:05 AM	#14
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	I got a RC4WD Outcry dual motor esc with fan and bec, accidentally shipped it to my parents house, Im picking it up this weekend. And just sent payment for a RC4WD Offroader 3ch 2.4 radio that I found on the classifieds here, should be here some time next week.

01-10-2011, 06:31 AM	#16
opie Quarry Creeper Join Date: Feb 2006 Location: Johnson Posts: 227	I just got my new trail honcho. I have it mostly built now but I'm still aways from having it done. But my AX10 it ready to go anytime. I wish there was an indoor crawling area. I really want to go crawling.

01-13-2011, 01:06 AM	#18
BJK Newbie Join Date: Mar 2009 Location: woodbury Posts: 38	I have been putting mine outside the back door closing the door and driving while looking out the window.

01-14-2011, 06:51 AM	#19
Hyde802 Quarry Creeper Join Date: Sep 2010 Location: Berlin, VT Posts: 275	Haha. Yup, thats what the flash light is for. So I can go beyond the outside light and still know where the truck is!

RCCrawler Forums

Thread: What next