Jethrobodean
Pebble Pounder
Seems basic, & not far off from solid rod/welding prep other than #5, I would not have thought about that.
-
Welcome to RCCrawler Forums.
It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!
Already a member? Login at the top of this page to stop seeing this message.
Brazing Video
- Thread starter Double J
- Start date
freddyg
Rock Stacker
pretty much, just more sensitive to contamination.
motopreserve
Quarry Creeper
Great thread. Thanks so much for all the info here!
Quick question: are you guys using shaded goggles for an oxy/map mix? I have always used these in the past (safety first!) - but I'm having a hard time spotting the flux/steel turn color, which I'm finding critical to know when it's ready for the silver.
Appreciate the help.
Quick question: are you guys using shaded goggles for an oxy/map mix? I have always used these in the past (safety first!) - but I'm having a hard time spotting the flux/steel turn color, which I'm finding critical to know when it's ready for the silver.
Appreciate the help.
mjderstine
SuperShafty.com
always wear goggles.
i use mapp so it doesnt heat that much. you shouldnt' need a hot red glow , so you should be ok with just safety sunglasses i would assume.
i use mapp so it doesnt heat that much. you shouldnt' need a hot red glow , so you should be ok with just safety sunglasses i would assume.
motopreserve
Quarry Creeper
Thanks for the reply. I figured as much. My goggles flip up - I think that will work out best.
LeoAndRei
Newbie
Anyone know if the Oxy/Map tanks on a Bernzomatic Oxy/Map torch kit can be swapped out for something larger? I was gifted the kit a while ago, but the tiny tank's are a P.I.T.A.
jwall046
Rock Crawler
is the video still available?
I looked on 1st page and I think its gone?
ty
I looked on 1st page and I think its gone?
ty
wingnutcrawler
Pebble Pounder
without reading every post on here I was wondering if someone could answer a simple question. I need to use screws to hold a few part needing brazing to a fixture. I was going to use aluminum screws so they don't get brazed too. what does everyone use in this situation. I wonder if titanium screws could be used? thanks in advance
