Cheap brushless setup

[curve]

Okay I know this is run in the ground over and over, but I am on a budget now and I have to be as cheap as possible. Here is what I have:

--Rock bull III full metal chassis (16" wheelbase)
--Narrowed 40 series commando beadlocks
--40 series moab xls
--twin 995 mg servos
--locked clod axles
--4ch Airtronics stick radion on 75mhz ground frequency

Now the question??? What would be a good cheap Brushless setup for crawling with my rig. I need the know what esc , motor, and batteries would be my best interest. Did I mention CHEAP. I really want to try brushless. I also need to know if I need a reciever pack and all of that good stuff. Also I would like to have front and rear dig so I'm assuming I will need 2 escs and batteries. Any help with this and I know alot of you guys have built on a budget so you know what I'm talking about.

I have a PTI Goliath that I love and this will be my first clod. You can email me at curve10780@aol.com or pm me or just post right here. Thanks ahead of time.

 

[Kranberry]

ide like to know what a cheep brush less set up is also...but for a 1.9-2.2 scaler:?:

 

[JohnRobHolmes]

Im working on a cheaper combo at the moment. Cheap wont happen in a clod though, you need two esc's and two motors.

 

[curve]

I just need cheaper than mamba and hyperion Just cheap as possible.

 

[Kamikaze]

I have tried several brushless setups in a clod...........at the moment cheap won't cut it, you would be beter off with lathes than a crappy brushless system.

 

[curve]

That's what I was wondering, I don't compete I just like to play alot and crawl every chance I get.