-
Welcome to RCCrawler Forums.
It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!
Already a member? Login at the top of this page to stop seeing this message.
Driveshaft lenght
- Thread starter Damond
- Start date
Natedog
I wanna be Dave
I don't know the exact lengths off-hand (can measure later if you want), but the rear should use two longest pieces (male/female) and front the two next longest pieces from the kit. "thumbsup"
Natedog
I wanna be Dave
You're welcome, compressed lengths: front measured about 95mm and rear about 105mm.
Buy the Vanquish Products driveshaft adapters for Ascenders and run whatever smaller diameter and more scale looking shafts you want. I bought them and mocked up on my WB K10 last night!
ASCENDER DRIVESHAFT ADAPTER
SKU: VPS08200
https://www.vanquishproducts.com/ascender-driveshaft-adapter/
SCX10ii or TRX-4 shafts will work, might need to trim or swap the different lenght parts around.
Buy the Vanquish Products driveshaft adapters for Ascenders and run whatever smaller diameter and more scale looking shafts you want. I bought them and mocked up on my WB K10 last night!
ASCENDER DRIVESHAFT ADAPTER
SKU: VPS08200
https://www.vanquishproducts.com/ascender-driveshaft-adapter/
SCX10ii or TRX-4 shafts will work, might need to trim or swap the different lenght parts around.
