I got a set of Kongs. Tried them once and decided I needed to narrow them. I read DD's article. I have two questions. After I cut the tire in half, I noticed a seem on each half. Is that what you used to make your measurment from? Did you measure 1/4" from that seem toward the center of the tire to come up with a total of a 3" overall tire width?
-
Welcome to RCCrawler Forums.
It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!
Already a member? Login at the top of this page to stop seeing this message.
Kong tire narrowing?
- Thread starter Trac95ker
- Start date
That's what I did and it worked great, 1/4 inch from the seam. I also used a marine rubberized adhesive (home depot) that has held up great and it flexes perfect. I put the 2 halfs on maxx rims and flipped the tire bead out so I could get my hand in the tire better to apply the glue. align the tire tread and applied and layer of glue between the 2 seams. also applied a second coat about as high as the seams too. 
DirkDigler
I wanna be Dave
- Joined
- Jan 28, 2004
- Messages
- 5,027
Good luck and have fun with it!
