• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

mamba max pro settings for wraith

drzjohn

Rock Crawler
Joined
Jan 17, 2006
Messages
623
Location
Derbyshire UK
What settings are you guys running on the mamba max pro on the wraith ? I am running a tekin redline 10.5 motor ,I think I have mine almost sorted but I am not sure what the "start power" should be set at ?
Thanks in advance "thumbsup"
 
What i did was lower the power level so it runs slow until i hit it hard. I have a 13.5 tekin pro 4 3300kv with 13/38 butt gears and it runs slow enough now to do some rock crawling but goes like hell when you nail it. Just play with the program and start out slow. I would not run max on any of the programs until you find out what that 10.5 is going to be like. This is from a guy who went through four motors and three esc and many drive shafts and steering knuckles last summer on one car before i turned down the power. Good luck.
 
Back
Top