• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

RC plane flyers...

Nice build, here is mine after 11 hours.

pic2465734577445.jpg
 
NICE! thats the exact plane dad wants, flatouts cap. weve heard horrible things about how brittle the foam is and that the hinges are $hitty, whats your thoughts?
 
Hasn't been in the air yet, waiting on servos. Don't get me started on the hinges, they are crap. The idea is good, but when you try and snap them together, they break half/most the time. But I learned a little trick.

Take some side cutters and just barely clip a little bit off the hinge then they should snap together fine. and still hold the surfaces together with out a problem.
 
got her all finished up. as soon as my servo extensions and y harness comes in, i can finish up the electronics and get airborn. i designed/cut/installed the graphics myself.
i wanted a design that was simple, represented the bowtie :D, showed well in a harrier/hover, and was dark/busy on top, and simple/bright on bottom for orientation. pretty basic, but im pleased with how it came out.
ignore the clown wheels they came with the kit:-(

graphics1es4.jpg


graphics2gs6.jpg


graphics3ro4.jpg


graphics4kd5.jpg
 
Back
Top