Brushless toyzuki

[ossipeecrawler]

Looking at going holmes brushless in my v2 toyzuki iv always ran brushed because i love the low end power and smooth startups. Does anybody here
run brushless in there toyzuki if so what kv stubby or standard? looking for smooth startup and enough power to clean out the wheels still want to keep the rig pretty light so i was considering going with the stubby?

[malickie]

Standard has better lower end resolution than the stubbies do. I don't own a Toyzuki but I have found that a 2700kv is a good middle of the road, some like the lower 2200kv but the 2700kv will give a bit better wheel speed when needed without losing much lower end resolution.

[ossipeecrawler]

Don't know if the standard would fit in a toyzuki motor is pretty low

[malickie]

Stubby per HH Page is 36mm diameter, 44mm length and Standard is 36mm diameter, 53mm length so you should be able to figure it out with those measurements.

[GrimmTheTourist]

I run the stubby 3300kv in my SCX2 and can not say a bad thing about low end resolution. Great little motor.
Maybe the standard is even better, but I cant complain at all and I have the crawl master pro 16T in my D90 to compare to.

[malickie]

I have both the 2700kv stubby and the 2700kv standard, initially had the stubby because the standard was sold out when I was looking, now that sits in another vehicle. Either way the Standard has a slightly better low end resolution, nothing too noticeable though so really can't go wrong with either at the end of the day.

[ossipeecrawler]

Thanks for the imput ended up ordering the 2700 stubby yesterday