| |
04-05-2019, 08:49 AM
| #1 |
| Newbie Join Date: Mar 2016 Location: Royal Oak
Posts: 46
|  Transmissions
How have the new “metal” transmission gears been holding up in the RTRs? Typically the idler gear has been the first upgrade I’ve done on my older trucks. Getting ready for a new build.
|
|  |
| Sponsored Links | |
| | |
|
04-05-2019, 08:59 AM
| #2 |
| I wanna be Dave Join Date: Oct 2010 Location: Caldwell ID.
Posts: 4,328
| Re: Transmissions
I ran a 3k 4 pole brushless in mine for a while on 3s. Zero issues. People have been having issues breaking screws off in the housing due to the tough plastic. A 3mm tap is recomended. |
|
| |
|
04-05-2019, 09:41 AM
| #3 |
| Rock Crawler Join Date: Jan 2019 Location: Calgary
Posts: 566
| Re: Transmissions
I run a 2280kv 4 pole on 3s, I'm not easy on it and have had zero issues.
|
|
| |
|
04-06-2019, 07:17 AM
| #4 |
| I wanna be Dave Join Date: Jun 2016 Location: Deep in the Everglades
Posts: 5,818
| Re: Transmissions
2700 Holmes on 3s No issues at all Hang up and Drive |
|
| |
|
04-06-2019, 02:32 PM
| #5 |
| RCC Addict Join Date: Feb 2016 Location: Santa Maria, CA
Posts: 1,751
| Re: Transmissions
Same here. 540 Revolver (fourteen pole brushless outrunner) on 3s with 2.2"s, so far, so good! At ~$6, the sintered metal (particle board of the metal world!) were worth a shot, I haven't been disappointed and have put these tranny gears in a few Wraiths now too.
|
|
| |
 |
Transmissions - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transmissions? | Du4designs | Micro Scale Rigs | 3 | 11-16-2017 08:06 PM |
| Transmissions? | DukeMinnix | General Scale Talk | 8 | 09-19-2017 05:36 PM |
| Transmissions | aussie_N_B | Newbie General | 2 | 09-18-2006 05:56 AM |
| Transmissions, Transmissions! Pros, Cons, All different typ | kevinlongisland | General Crawlers | 5 | 06-21-2004 05:49 PM |
| |
Linear Mode
