|
| LinkBack | Thread Tools | Display Modes |
07-20-2013, 12:44 AM | #1 |
Newbie Join Date: Jun 2013 Location: Long Beach
Posts: 16
| Trouble with vanquish steering knuckle
Can not get bearing to seat, the bearing is flush but will go no futher.
|
Sponsored Links | |
07-20-2013, 06:22 AM | #2 |
I wanna be Dave Join Date: Sep 2005 Location: Houston, TX
Posts: 16,952
|
Can you post a pic? The bearings sit a little cockeyed in those knuckles due to the king pin inclination...
|
07-20-2013, 09:46 AM | #3 |
Newbie Join Date: Jun 2013 Location: Long Beach
Posts: 16
| Re: Trouble with vanquish steering knuckle
Hi Jeremy thanks for your response, I tried to post pic with no luck. Somehow I installed these on my Poison Spider RTR with no problem also one side of this wraith kit. Right now the bearing is sitting flush, I can not pop it out at this point so needless to say the build as come to a halt. Thanks for any help. |
07-20-2013, 10:14 AM | #4 |
I wanna be Dave Join Date: Feb 2011 Location: Atlanta, GA
Posts: 2,650
| Re: Trouble with vanquish steering knuckle
Take the bearing out of the knuckle. Put the bearing onto your steering axle shaft, universal, VVD whatever you're using to steer with. Then pull the shaft through the knuckle...it should help you seat the bearing properly. Pull the steering shaft out and check the bearing before moving further.
|
Trouble with vanquish steering knuckle - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
XR steering trouble shooting | Curcal | Axial XR10 | 4 | 06-08-2012 12:05 PM |
Vanquish Wraith C-Hub & Steering knuckle Video Review & Install | FastEddy | Axial Wraith | 0 | 10-28-2011 01:04 PM |
inside tyre touches steering knuckle / steering linkage | murky123 | Axial SCX-10 | 4 | 10-06-2010 04:46 PM |
First Project and steering trouble | Brandon502 | Electronics | 3 | 09-03-2005 06:56 PM |
| |