Need some slipper setup help.

[Markeje]

I got the slash high performance slipper kit from Robinson Gear for the wraith tranny. This is what supershafty has on their site for the 32p .8 mod slipper upgrade.
I'm having trouble installing though.
If I remove the original aluminum back plate the new one seats to deep and hits the motor mount plate. What am I missing? I'll post a pick when my phone starts working better.

Sent from my SCH-I545 using Tapatalk

[altd896]

have you got an extra bearing in there as a spacer as well as the plastic piece?



Harley's Axial Wraith Build - Jimmy's 4x4 Ultra 4 KOH Style

[Markeje]

Ahhh ok. Thanks altd896!!!


Sent from my SCH-I545 using Tapatalk

[altd896]

Someone else asked so I'll add the info here as well

the plastic bush is a stock axial trans part
[/URL]

or they have an upgrade ali part as well AX30499
Axial Trans Spacer 5x6.9x4.8mm (2)

The slipper being for a traxxas trans won't mention the spacer or bearing being required for the Axial trans.
I'd happened to see one of Harleys posts (which is where that pic came from) about assembling the SuperShafty shaft & slipper & thats where I'd seen the bearing.

The Wraith & SCX cases are both the same at that part, my understanding is they should need the bearing & spacer

[Curb Crawler]

Have used the SS Beefy top shaft as well?

[SteveC6R]

Link to the mod with top shaft from SS: http://www.rccrawler.com/forum/axles...imate-mod.html

[JDIRCC]

This is why i love and hate this site at the same time. Just sitting around reading some threads and then bam read this and start ordering parts again when i thought i was done for a while lol. Starting to be worse than my addiction to building real crawlers. Went to order the stuff mentioned above for trans and bam there goes another $250 bucks before i knew it. gotta love this addiction though.

[SteveC6R]

Your not lying there! Harley owes me a steak dinner at the very least! Damn him and his threads!