|
| LinkBack | Thread Tools | Display Modes |
03-08-2015, 10:06 PM | #1 |
Pebble Pounder Join Date: Mar 2015 Location: Fairland
Posts: 103
| Spawn hex adapter problem The issue if you cannot tell is that the adapter binds on the knuckle. In the rear it binds on the lockouts. Are there special hex adapters for the wraith or what? Can you provide me a link if there are...thanks! |
Sponsored Links | |
03-09-2015, 10:33 AM | #2 |
Newbie Join Date: Jun 2013 Location: Menlo Park
Posts: 18
| Re: Spawn hex adapter problem
you left the pin in the axle right?
|
03-09-2015, 11:04 AM | #3 |
Pebble Pounder Join Date: Mar 2015 Location: Fairland
Posts: 103
| Re: Spawn hex adapter problem
lol...yes of course....that is like the whole, "It's plugged in right" question. Obvious but always worth asking.... |
03-09-2015, 11:59 AM | #4 |
RCC Addict Join Date: Aug 2013 Location: Missoula
Posts: 1,346
| Re: Spawn hex adapter problem
Looks like the axle is pushed in so far its hitting the axle housing?
|
03-09-2015, 01:44 PM | #5 |
Newbie Join Date: Jun 2013 Location: Menlo Park
Posts: 18
| Re: Spawn hex adapter problem
I know it was a stupid question and I was going to say that, but if you didn't have the pin in I would have felt like a dick Ya, looks like pin depth in the hex adapter is too deep |
03-09-2015, 03:05 PM | #6 |
I joined the Band! Join Date: Dec 2014 Location: Earth
Posts: 1,188
| Re: Spawn hex adapter problem
The Wraith and SCX10 hex are different, but both have a pin depth of about 2mm. Pin depth is either too deep or the bearings are not seated fully in the knuckles and lockouts. Who's hex are you trying to use? I've got some that are only 1.5mm deep and other that are dead on 5mm, so it can make a difference. |
03-10-2015, 06:40 AM | #7 |
Pebble Pounder Join Date: Mar 2015 Location: Fairland
Posts: 103
| Re: Spawn hex adapter problem
A buddy of mine gave me a set of axial wheels with the better beadlock than stock. He also gave me the adapters he used. He owns 3 scx10's so that is what they are for. The bearing is fully seated I made sure of that when I when through and repacked all the bearing with marine grease.
|
03-10-2015, 09:15 AM | #8 |
I joined the Band! Join Date: Dec 2014 Location: Earth
Posts: 1,188
| Re: Spawn hex adapter problem
Standard SCX10 hex should fit the Wraith, but some aftermarket manufacturers will occasionally design their parts fit their other parts instead of the factory components. If your axles are not stock it may be the issue or the hex themselves are just not designed as a direct fit on the stock axle.
|
Spawn hex adapter problem - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
17mm to 12mm hex adapter? | Ecranu | Tires and Wheels | 2 | 01-15-2015 03:08 PM |
Adapter to 12mm hex? | kranswall | Traxxas Crawlers | 6 | 02-12-2012 09:24 PM |
14mm to 17mm hex adapter | Unholy | General Crawlers | 12 | 09-29-2006 10:35 PM |
| |