| |
10-05-2016, 02:06 PM
| #1 |
| Newbie Join Date: Mar 2015 Location: northwest
Posts: 37
|  titanium gear shafts
was wondering who all runs the titanium gear shafts in the xr10 gear boxes.and have you done the bushing mod or the bearing mod
|
|  |
| Sponsored Links | |
| | |
|
10-06-2016, 04:38 PM
| #2 |
| RCC Addict  Join Date: Oct 2011 Location: British Columbia
Posts: 1,487
| Re: titanium gear shafts
I have 'em front and rear with VP cases. Still have the bearings and no issues over 3 year's use. Although, I'm not hard on my trucks and I did do the two-bolt mod on the rear.
|
|
| |
|
10-07-2016, 05:15 AM
| #3 |
| Custom Carbon Fiber   Join Date: Oct 2007 Location: Connecticut :(
Posts: 4,501
| Re: titanium gear shafts
I ran one in the rear but switched the front back to the steel one after snapping a Ti one at the pin hole. The front takes the most abuse and Ti flex's more then steel so they tend to break. I run a delrin bushing I made years ago and never had a gear failure from that. |
|
| |
 |
titanium gear shafts - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Titanium Shafts | ZoSo | RCP Crawlers | 30 | 04-16-2014 10:23 AM |
| Titanium Shafts | ZoSo | New Products and Great Deals | 0 | 07-22-2013 08:33 AM |
| Axial Titanium Gear Shafts for the XR10 | BENDER | Axial XR10 | 53 | 07-09-2012 11:41 PM |
| Metal Gear vs Titanium Gear | rctoyguy | Electronics | 4 | 02-15-2010 09:59 PM |
| titanium tlt shafts | supercrawlerfreak | Chit Chat | 70 | 10-22-2006 04:54 PM |
| |
Linear Mode
