RCCrawler Forums

Redneck Crawlin · 06-01-2007, 12:27 AM

I just managed to drill a 1 inch deep hole in my leg... it hurts real bad lol ow

joemomma95 · 06-01-2007, 12:39 AM

I sliced my finger the other day trimming up the cutting board with a utility knife, went deep but for some reason it didn't bleed at all hardly. I put a paper towel on it and kept working....really stupid mistake on my part, I knew better.

Then I was trying to drill a hole in the chassis and didn't want to take the truck apart, so I was holding the other side of the chassis from where I was drilling. The bit made it's way through the aluminum and proceeded into my thumbs fingernail, right at the base and got some skin too. Went into the nail far enough to pull some into the bit but it didn't make a hole, lucky me!

I was way to tired to be doing anything that day, and now I have proof of it

..

clodstall · 06-01-2007, 05:22 AM

ive shot thru mine with a nail gun 2 times in the past.

run2jeepn · 06-01-2007, 05:35 AM

I've been stabbed in the hand during Training...

xjwalt666 · 06-01-2007, 05:39 AM

i got shot 2 times with a 22 and 5 times with a bb gun. also had a 2x4 dropped 20 feet and landed on my head.

davway · 06-01-2007, 06:12 AM

ive had a rusty 10mm round steel bar through my foot when i was about 13. it was attached to a rusty gate....long story. missed EVERY bone which was lucky and was sticking out the other side of my foot almost 40cm.
had a steel spike about 2 inches long penetrate the back of my ankle. rubbed against my achillies tendon...that was close. heres a tip. dont use your foot to try and push a cow into the cattle crush if it doesnt want to go.
accidently stabbed a screw driver into the webbing of my thumb...with force....that ****'s hollow in there!
plenty of other stupid things over the years.

heres a funny one too. apparantly when i was really little i was riding my bike as fast as i could, lost it and smashed headfirst into a brick wall. still to this day i have 2 lump like ridges on the back of my head and a bald spot on each of them.
dont ask how you can ride the back of your head into a brick wall....i dont know either.

Cole82 · 06-01-2007, 06:17 AM

When I was about 15 I dropped a 3 ball hitch onto my right big toe. I wasn't wearing shoes at the time. The square end cut my toe off from the base of the nail forward. It was just bairly hanging on at the bottom.

Here is what the hitch was like. http://www.truckstuffusa.com/tripleh...tbyvalley.html

S-Dog · 06-01-2007, 06:33 AM

I shot a ring nail into my knee with a nail gun. The doctor had to use regular pliers to pull it out.

truckerbuddy2 · 06-01-2007, 07:08 AM

back in high school i was workin for the shop teachers construction company cleaning up trash and steped on a 3 inch long nail, went through my boot up into my foot. aint never fun.

Kamikaze · 06-01-2007, 08:12 AM

This thread is worthless without PICS!!!!

Ninja · 06-01-2007, 08:13 AM

I ripped my hand open in shop class trying to adjust the cutting bit on a bigass engine lathe. It went 3/8" deep and 1 3/4" long.

Mikekx65 · 06-01-2007, 08:26 AM

there was this one time where i got a splinter pretty bad aint it??

lol j/k i broke both my wrists jumping off a swing set in 3rd grade

ON THE FARM · 06-03-2007, 12:17 AM

bad pic but its a pic.

i was in a hole about 15 feet deep welding a flange on a pipe, it was a broken water pipe. i was lining up the fglange with the other using a spud wrench and some how i got my finger stuck in one of the holes and the hole was starting to fill up with water. the other guys i was working with were fitting a valve on top so they did not hear me yelling for help. in a matter of minutes the water was up to my chest, all i had that i could get to was a pair of dykes. yep................ i did it! like the guyn stuck under the bolder i had to brake my finger and cut it off with the dykes. this november it will have been 7 years.
it is funny when i tell this story to pepole some have puked and one girl fainted!

some times i dont have the heart to tell them that it is not a true story. but i did cut my finger off with the help of a table saw

Redneck Crawlin · 06-03-2007, 12:36 AM

Quote:

Originally Posted by ON THE FARM

some times i dont have the hart that it is not true

uhh............ what?

and ow

ON THE FARM · 06-03-2007, 12:50 AM

Quote:

Originally Posted by Redneck Crawlin

uhh............ what?

and ow

sorry i fixed the last part

Redneck Crawlin · 06-03-2007, 12:59 AM

lol either way it still has gotta hurt lol

Cole82 · 06-03-2007, 05:46 AM

Hub cap thread from last year. Some good pics in there.
Hub Caps Suck

Lumpmister · 06-03-2007, 09:57 AM

I once dropped a grinder and it almost cut of my finger and cut a long gash in my leg. I had learned my lesson

ON THE FARM · 06-03-2007, 02:34 PM

griners and skin = pain!
i was using a wire cup on a grinder removing paint, it bounced and cought my leathers and tore them and my shirt right off.

ClodMonster · 06-03-2007, 02:49 PM

When i was about 12 I was riding my bike and i hit a storm drain, flipped my bike and gashed my knee down to the bone, and about 2 inches long took allot of stitches and couldn't do any exercise for 3 months, it sucked

06-01-2007, 12:27 AM	#1
Redneck Crawlin I joined the Band! Join Date: Apr 2007 Location: In a trance Posts: 32	Anyone impailed/mangaled/manged anything? I just managed to drill a 1 inch deep hole in my leg... it hurts real bad lol ow

06-01-2007, 06:12 AM	#6
davway Quarry Creeper Join Date: Nov 2005 Location: Australia Posts: 282	ive had a rusty 10mm round steel bar through my foot when i was about 13. it was attached to a rusty gate....long story. missed EVERY bone which was lucky and was sticking out the other side of my foot almost 40cm. had a steel spike about 2 inches long penetrate the back of my ankle. rubbed against my achillies tendon...that was close. heres a tip. dont use your foot to try and push a cow into the cattle crush if it doesnt want to go. accidently stabbed a screw driver into the webbing of my thumb...with force....that ***'s hollow in there! plenty of other stupid things over the years. heres a funny one too. apparantly when i was really little i was riding my bike as fast as i could, lost it and smashed headfirst into a brick wall. still to this day i have 2 lump like ridges on the back of my head and a bald spot on each of them. dont ask how you can ride the back of your head into a brick wall....i dont know either. Last edited by davway; 06-01-2007 at 06:15 AM.*

06-03-2007, 12:17 AM	#13
ON THE FARM Quarry Creeper Join Date: Aug 2006 Location: NORTH TEXAS Posts: 202	bad pic but its a pic. i was in a hole about 15 feet deep welding a flange on a pipe, it was a broken water pipe. i was lining up the fglange with the other using a spud wrench and some how i got my finger stuck in one of the holes and the hole was starting to fill up with water. the other guys i was working with were fitting a valve on top so they did not hear me yelling for help. in a matter of minutes the water was up to my chest, all i had that i could get to was a pair of dykes. yep................ i did it! like the guyn stuck under the bolder i had to brake my finger and cut it off with the dykes. this november it will have been 7 years. it is funny when i tell this story to pepole some have puked and one girl fainted! some times i dont have the heart to tell them that it is not a true story. but i did cut my finger off with the help of a table saw Last edited by ON THE FARM; 06-03-2007 at 12:52 AM.

06-01-2007, 12:39 AM	#2
joemomma95 Rock Crawler Join Date: Dec 2006 Location: Sierra Vista Posts: 672	I sliced my finger the other day trimming up the cutting board with a utility knife, went deep but for some reason it didn't bleed at all hardly. I put a paper towel on it and kept working....really stupid mistake on my part, I knew better. Then I was trying to drill a hole in the chassis and didn't want to take the truck apart, so I was holding the other side of the chassis from where I was drilling. The bit made it's way through the aluminum and proceeded into my thumbs fingernail, right at the base and got some skin too. Went into the nail far enough to pull some into the bit but it didn't make a hole, lucky me! I was way to tired to be doing anything that day, and now I have proof of it ..

06-01-2007, 05:22 AM	#3
clodstall I lost my vendor privileges Join Date: May 2006 Location: TOP OF THE HILL Posts: 3,014	ive shot thru mine with a nail gun 2 times in the past.

06-01-2007, 05:35 AM	#4
run2jeepn I wanna be Dave Join Date: Sep 2005 Location: USA Posts: 11,196	I've been stabbed in the hand during Training...

06-01-2007, 05:39 AM	#5
xjwalt666 Quarry Creeper Join Date: Jan 2006 Location: colchester Posts: 496	i got shot 2 times with a 22 and 5 times with a bb gun. also had a 2x4 dropped 20 feet and landed on my head.

06-01-2007, 06:17 AM	#7
Cole82 I wanna be Dave Join Date: Jul 2005 Location: Cedar Rapids Posts: 2,028	When I was about 15 I dropped a 3 ball hitch onto my right big toe. I wasn't wearing shoes at the time. The square end cut my toe off from the base of the nail forward. It was just bairly hanging on at the bottom. Here is what the hitch was like. http://www.truckstuffusa.com/tripleh...tbyvalley.html

06-01-2007, 06:33 AM	#8
S-Dog Rock Crawler Join Date: May 2006 Location: Burrillville, RI Posts: 778	I shot a ring nail into my knee with a nail gun. The doctor had to use regular pliers to pull it out.

06-01-2007, 07:08 AM	#9
truckerbuddy2 Quarry Creeper Join Date: Aug 2006 Location: louisiana Posts: 324	back in high school i was workin for the shop teachers construction company cleaning up trash and steped on a 3 inch long nail, went through my boot up into my foot. aint never fun.

06-01-2007, 08:12 AM	#10
Kamikaze I wanna be Dave Join Date: Oct 2005 Location: Columbia TN Posts: 6,154	This thread is worthless without PICS!!!!

06-01-2007, 08:13 AM	#11
Ninja Rock Stacker Join Date: Feb 2006 Location: Ringgold Posts: 74	I ripped my hand open in shop class trying to adjust the cutting bit on a bigass engine lathe. It went 3/8" deep and 1 3/4" long.

06-01-2007, 08:26 AM	#12
Mikekx65 Rock Crawler Join Date: Apr 2007 Location: LaSalle Posts: 819	there was this one time where i got a splinter pretty bad aint it?? lol j/k i broke both my wrists jumping off a swing set in 3rd grade

Sponsored Links

06-03-2007, 12:59 AM	#16
Redneck Crawlin I joined the Band! Join Date: Apr 2007 Location: In a trance Posts: 32	lol either way it still has gotta hurt lol

06-03-2007, 05:46 AM	#17
Cole82 I wanna be Dave Join Date: Jul 2005 Location: Cedar Rapids Posts: 2,028	Hub cap thread from last year. Some good pics in there. Hub Caps Suck

06-03-2007, 09:57 AM	#18
Lumpmister Pebble Pounder Join Date: Apr 2007 Location: Pacific Ocean Posts: 181	I once dropped a grinder and it almost cut of my finger and cut a long gash in my leg. I had learned my lesson

06-03-2007, 02:34 PM	#19
ON THE FARM Quarry Creeper Join Date: Aug 2006 Location: NORTH TEXAS Posts: 202	griners and skin = pain! i was using a wire cup on a grinder removing paint, it bounced and cought my leathers and tore them and my shirt right off.

06-03-2007, 02:49 PM	#20
ClodMonster Rock Stacker Join Date: Aug 2005 Location: Hiding in a Cornfield Posts: 65	When i was about 12 I was riding my bike and i hit a storm drain, flipped my bike and gashed my knee down to the bone, and about 2 inches long took allot of stitches and couldn't do any exercise for 3 months, it sucked

RCCrawler Forums

Thread: Anyone impailed/mangaled/manged anything?