11-14-2011, 04:24 PM | #1 |
Rock Stacker Join Date: Jun 2011 Location: Australia
Posts: 56
| Cc bec
Hey Guys, A have a new CC BEC and I am wondering which Port I should plug the cord into on my Spektrum AR600. E.G. BIND/DATA port or Landing Gear port or Auxillery port e.t.c Thanks, Jayden |
Sponsored Links | |
11-14-2011, 04:36 PM | #2 |
I wanna be Dave Join Date: Sep 2005 Location: Houston, TX
Posts: 16,952
|
Any port will work. |
11-14-2011, 04:39 PM | #3 |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| |
11-26-2011, 02:32 PM | #4 |
Newbie Join Date: Sep 2011 Location: france
Posts: 9
| plug Bec
Hi guys, I'm just about to plug my AR600 spektrum, with a castle creation on the AUX channel of the AR600. I have just red that you dont recommand it ? Can you tell me why ? My setup is: XR10 4WS reciever ar600 spektrum Channel Thro = Front esc (tekin FXR) Channel Aile = Rear ESC (tekin FXR) Channel Elev = Rear servo steering (hitec HS 7954 SH) Channel Rudd = Front servo steering (hitec 7954 SH) Channel Aux1 = CC bec castle creation Thanks Last edited by rc777; 11-26-2011 at 02:45 PM. |
11-26-2011, 03:01 PM | #5 | |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| Quote:
If you want to run the external BEC through the RX, remove the red wire that goes from the ESC to the RX (DON'T cut it off, just remove it from the RX connector and tape it up) and let the external BEC power everything. | |
11-27-2011, 03:12 AM | #6 | |
Newbie Join Date: Sep 2011 Location: france
Posts: 9
| BEC with AR600 Quote:
My question is : Is it ok to power my AR600 with the castle BEC thought the AUX1 channel ??? Here is a picture. of my mounting. Uploaded with ImageShack.us | |
11-27-2011, 03:16 AM | #7 |
Rock Crawler Join Date: Oct 2009 Location: Brussels
Posts: 616
|
You can power it thru any port |
11-27-2011, 03:18 AM | #8 |
Newbie Join Date: Sep 2011 Location: france
Posts: 9
| |
11-27-2011, 08:32 AM | #9 | |
I wanna be Dave Join Date: Nov 2010 Location: 07456 N. NJ USofA
Posts: 8,314
| Quote:
Some radios (mostly Spektrum) really want the black wire from the external BEC to go to the RX to stop glitching. Futaba's seem to do fine without that change. I also have had a few CC BEC's die by going to full battery power, I'm not sure the RX would be happy getting 3S LiPO power direct into it. And yes, you can run the BEC output to any open RX port if that is the method you chose. | |
11-27-2011, 08:59 AM | #10 | |
Newbie Join Date: Sep 2011 Location: france
Posts: 9
| Quote:
Thank very much charlie III for those infos | |
| |